Harmar Mobility csl500, Installation & Service Manual

Page: 7 / 24

HELIX:
Install Manual
24SEP2021 | 630-00063-01 REV D
7
INSTALLATION
HELIX CURVED STAIR LIFT: SECTION 3
SECTION 3
INSTALLATION
The standard installation will require two installers
and should take approximately three hours to
complete. The time will vary depending on the
complexity of the lift ordered and custom designs.
1. Review installation drawing. The dimensions on
the drawing show numbers on the stairs. These
numbers indicate the position of the supports.
See Figures 3-1 and 3-2.
Figure 3-1
NOTE: S is the leg position. F is the rail stabilizer and does
not go to the floor.
Figure 3-2
NOTE: You may complete the wiring while putting the rail
together or use a fish tape on the completed unit to run
the wire.
2. Carry the chair and chassis to the location of the
installation. Usually this will be at the top of the
stairs. It is best to install the chassis on a flat
section of rail.
3.
Position the stair supports. Place stair supports
on the stair based on the installation drawing,
but do not bolt down at this point.
See Figure 3-3.
Figure 3-3