Harmar Mobility csl500, Installation & Service Manual

Page: 10 / 24

HELIX:
Install Manual
24SEP2021 | 630-00063-01 REV D
10
INSTALLATION
HELIX CURVED STAIR LIFT: SECTION 3
4.
TEST RUN. Prior to bolting down the supports,
install the chassis and run it on the rail to check all
clearances. It may be necessary to bolt down one or
two legs to hold the rail in place. If necessary, move
the rail position to provide the best fit.
NOTICE
To use install switch, press the emergency safety
switch in, if you do not have that option,
separate the male female connector. After using
the install switch, release the safety or put the
wires back together. See Figure 3-15.
Figure 3-15
CHASSIS INSTALLATION
1. Ensure that the charging strips are oriented on
the top of the bottom rail. See Figure 3-16.
Figure 3-16
2. Install the loading bar. See Figure 3-17.
Figure 3-17
3. Slide the chassis on until the pinion gear hits the
gear rack. Activate the installation rocker switch
to drive onto the rack, watching the wheels to
ensure they go on smoothly. Ensure the unit
goes down the gear rack about 6" (15.2 cm).
See Figure 3-18.
Figure 3-18
4.
If installing on a standard incline, tilt the upper
rollers to match the angle of the rails. This will
allow the chassis to slide on. See Figure 3-19.