Harman Martin Atomic 3000 LED User Manual Download Page 4

Page: 4 / 44

Atomic 3000 LED user manual

• Use only a source of AC power that complies with local building and electrical codes and has both

overload and ground-fault (earth-fault) protection.

• Before using the fixture, check that all power distribution equipment and cables are in perfect condition

and rated for the current requirements of all connected devices.

• Isolate the fixture from power immediately if the power cable, power plug or any seal, cover or other part is

damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs
have been completed and any defective parts have been replaced with new items.

• The cable used to connect the product to AC power must be 14 AWG or 1.5 mm

minimum conductor size

and heat-resistant to 90° C (194° F) minimum. It must have three conductors and an outer cable diameter
of 5 - 15 mm (0.2 - 0.6 in.). In the USA and Canada, the cable must be UL/CSA recognized, hard usage,
type SJT or equivalent. In the EU, the cable must be type H05VV-F or equivalent.

• Connect only a cable with a Neutrik PowerCON TRUE1 NAC3FX-W female connector to the fixture’s

power input socket.

P R O T E C T I O N F R O M B U R N S A N D F I R E

• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).

• The exterior of the fixture becomes hot during use. After 5 minutes of operation a surface temperature of

70° C (158° F) shall be expected, and the maximum steady state is 80° C (176° F). Avoid contact by
persons and materials. Allow the fixture to cool for at least 10 minutes before handling.

• Keep all combustible materials (e.g. fabric, wood, paper) at least 20 cm (8 in.) away from the fixture.

• Keep flammable materials (e.g. volatile liquids, pyrotechnics, fuel of any kind) well away from the fixture.

• Ensure that there is free and unobstructed airflow around the fixture.

• Do not illuminate surfaces within 1 m (3 ft. 4 in.) of the Atomic 3000 LED.

• Do not expose the front glass to sunlight or other strong light source from any angle. Lenses can focus the

sun's rays inside the fixture, creating a potential fire hazard.

• Do not attempt to bypass thermostatic switches or fuses.

• Do not modify the fixture in any way not described in this user manual or install other than genuine

Martin™ parts. Do not stick filters, masks or other materials onto any lens or other optical component.
Use only accessories approved by Martin™ to mask or modify the light beam.

P R O T E C T I O N F R O M E Y E I N J U R Y

• Do not look at LEDs with magnifiers, telescopes, binoculars or similar optical instruments that may

concentrate the light output.

• Do not operate the fixture with missing or damaged covers, shields or any optical component.

• To minimize the risk of eye irritation or injury, disconnect the fixture from power at all times when the

fixture is not in use, and provide well-lit conditions to reduce the pupil diameter of anyone working on or
near the fixture.

P R O T E C T I O N F R O M I N J U R Y

• To guard against risks from epileptic seizure:

- Do not operate the fixture near stairways, in corridors or near public exits.

- Provide advance notice that strobe lighting is in use. Display advisory notices at the point of ticket sales,

on tickets if possible, in the program, and at the entrance(s) to the venue.

- Avoid extended periods of continuous flashing, particularly at frequencies of 10 to 20 flashes per