Harman Martin Atomic 3000 LED, User Manual

Page: 24 / 44

24 Atomic 3000 LED user manual
Warning! Disconnect from power and allow to cool before cleaning.
To clean the fixture:
1. Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2. Vacuum or gently blow away dust and loose particles from the outside of the fixture and the air vents at
the back and base with low-pressure compressed air. Do not direct compressed air or air suction at fans,
as this may damage them.
3. If the air grills on the back of the fixture are not perfectly clean, see Figure 10. Remove the air grill
retaining screws A , swing the grills out and remove the grills from the back of the fixture. Clean the grills
with a soft brush and vacuum cleaner. If there is any oily residue on the grills, clean them in a detergent
solution, then dry them thoroughly. Reinstall the grills by first hooking the outside edge
B into the grill
aperture, then installing the screws A .
4. Clean the front glass by wiping gently with a soft, clean lint-free cloth moistened with a weak detergent
solution. Do not rub the surface hard: lift particles off with a soft repeated press. Dry with a soft, clean,
lint-free cloth or low-pressure compressed air. Remove stuck particles with an unscented tissue or
cotton swab moistened with glass cleaner or distilled water.
5. Check that the fixture is dry before reapplying power.
Control menu service utilities
The control panel SERVICE menu provides utilities for technicians rigging or servicing the fixture:
• ERROR LIST displays any error messages that are stored in internal memory.
• FAN CLEAN lets you set all cooling fans to run at maximum speed for a short period for cleaning
purposes.
• USB lets you update the firmware (fixture software) using a USB memory device. For a detailed guide to
updating the firmware, see the next section in this chapter.
Firmware installation
The currently installed firmware (fixture software) version can be viewed in the control panel INFORMATION
menu.
Firmware updates can be downloaded from the Martin™ website and can be installed using a USB memory
device or a Windows PC running the Martin Uploader application and either a Martin M-DMX USB-DMX
interface device or a Martin DABS1™ USB-DMX interface device.
Fixture information and settings are not normally affected when you install new firmware, but check the
firmware release notes and any service notes for the firmware version on the Martin™ website. These notes
will give details if updating to the new firmware will affect settings. A firmware update can also affect fixture
behavior and DMX control. If necessary, a new DMX protocol will be available with the release notes.
Do not switch the fixture off during a firmware update, or firmware may be corrupted.
Figure 10: Removing air grills
B
A A