5
FRONT PANEL CONTROLS
MEMORY TUNE / PRESET BUTTON
Press the TUNE/PRESET side of this button to light up the preset
mode then use the up/down buttons momentarily to scan the
preset station frequencies. The receiver stops at each preset
location from 1–30 that has been entered in memory. Hold the
button down to skip through the presets quickly. In the TUNE mode
press these buttons to change selected frequencies.
MEMORY BUTTON
Use this button to store an AM or FM frequency. Press this button
and select one of 30 preset locations to store the frequency with
the TUNE/PRESET buttons while the MEMORY indicator blinks,
press MEMORY again to store preset station.
NOTE: When you store a frequency in a memory location that
already contains a frequency, you replace the previous frequency.
If your receiver is disconnected from AC power for more than about
2 weeks, it loses all stored frequencies.
SEEK / STEREO BUTTON
Press this button, “Auto” will illuminate in the display. Then press
the TUNE/PRESET button. The tuner will automatically seek out
stations in your area that have enough signal strength to be listen-
able. The tuner will stop on stations until the SEEK/STEREO but-
ton is pressed again.
VOLUME CONTROL
Turn the VOLUME clockwise to increase the volume and counter-
clockwise to decrease it. The volume of the front, center, and rear
channels is changed at the same time.
DISPLAY WINDOW
This window shows the state of operation for easier control of the
receiver. It also contains the IR Remote Sensor.
16
15
14
13
12
JSR625 Owners Manual 7/28/98 10:54 AM Page 5
