INTRODUCTION
the harman clarity Direct vent 929Dv Gas heater is a
listed gas-fired direct vent room heater tested by Inchcape
testing/Warnock hersey to standard ansi Z21.88-2002-
csa 2.33-2002, and can/cGa-2.17-M91.
the installation of the clarity Direct vent Gas heater must
conform with local codes, or in the absence of local codes,
with national Fuel Gas code, ansi Z223.1 — latest edition
and can 1 B1-149.1 and .2 installation code.
also for use in mobile (manufactured) homes after home
is sited.
Mobile (manufactured) home installations must adhere
to the current edition of title 24 cFr, part 3280, or csa
Z240.4.
caution: this appliance must be vented to the out-
side.
installation and repair of the clarity Direct vent Gas
Heater should be done by a qualified service person. The ap
-
pliance should be inspected before use and at least annually
by a qualified service person. More frequent cleaning may
be required due to excessive lint from carpeting, bedding
material, etc. it is imperative that control compartments,
burners, and circulating air passageways of the clarity be
kept clean.
When operating your harman clarity Gas heater, respect
basic safety standards. read these instructions carefully
before you attempt to operate the heater. Failure to do so
may result in damage to property or personal injury and may
void the product warranty.
consult with your local building code agency and insur-
ance representative before you begin your installation to
ensure compliance with local codes, including the need for
permits and follow-up inspections.
several issues must be addressed when selecting a suitable
location for your clarity Gas heater. observing required
clearances to combustible materials, the proximity to a safe
chimney or venting system location, and the accessibility
of the gas and electrical supply must all be considered. in
addition, selecting a location that takes advantage of the
building's natural air flow is also desirable to maximize the
heating effectiveness of the heater. in many cases, this is a
central location within the building.
SAFETY NOTICE
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FAILURE
TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INjURY, OR EVEN DEATH.
FOR USE IN THE U.S. AND CANADA. SUITABLE FOR INSTALLATION IN MOBILE HOMES
IF THIS HARMAN STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOL-
LOW INSTALLATION DIRECTIONS.
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION
REQUIREMENTS IN YOUR AREA.
CONTACT YOUR LOCAL AUTHORITY (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT,
FIRE PREVENTION BUREAU, ETC.) TO DETERMINE THE NEED FOR A PERMIT.
CETTE GUIDE D'UTILISATION EST DISPONIBLE EN FRANCAIS. CHEz VOTRE CONCESSIONNAIRE DE HAR-
MAN HOME HEATING.
Advetissement: Quinconque ne respect
pas à la lettre les instructions dans le
présent manuel risque de déclencher un in-
cendie ou une explosion entraíant des dom-
mages matérials, des lésions corporelles ou
la perte de vies humaines. installation ou
modification, consulter le manuel des usag
-
ers fourn avec ce génerateur d'air chaud.
ne pas entreposer ni utiliser d'essence ni
d'autres vapeurs ou liquides inflammables
dans le voisinage de cet appareil ou de tout
autre appareil.
POUR vOtRe sÉCURitÉ: Que faire si vous
sentez une odeur de gaz:
• ne pas tenter d'allumer d'appareil.
• ne touchez à aucun interrupteur. ne pas
vous servir des téléphones se trouvant dans
le batiment où vous trouvez.
• Evacuez la pièce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur
de gaz depuis un voisin. suivez les instruc-
tions du fournisseur.
• si vous ne pouvez rejoindre le fournisseur
de gaz, appelez le service dos incendies.
