Advanced Functions - DAS-MET-6SRC
72
Metreau Keypads Instruction Manual
Working with Alarms
To use the Alarm feature, a System Time must first be entered on the Main Controller, via the Front LCD.
To set an alarm from each Keypad, select a Source, adjust the volume, and set the alarm time (using 24HR clock, as described
below).
When the alarm time is reached, the Source selected will turn On, and the volume will ramp up to the set volume and begin playing.
At this point the source will behave normally.
NOTE:
If a Favorite has been set, the Favorite will begin playing. Otherwise, the last station/CD will begin playing.
Setting the System Clock on the Tango Audio Controller
From the LCD on the front panel of the Tango Audio Controller:
1.
Select
CLOCK
2.
Select
Set Time
to display the following screen (FIG. 76):
3.
Press
Hour
to increment the HH (hours) from 1 through 24.
4.
Press
Minute
to increment the MM (minutes) from 01 through 60.
5.
Press
Second
to increment the SS (seconds) from 01 through 60.
6.
Press
Set
to set the clock to the time displayed.
Refer to the
Tango Audio Controller Operation/Reference Guide
for details.
Setting an Alarm in a Zone
1.
Select Source and adjust the Volume to desired level.
2.
Press and hold buttons
5 and 6
simultaneously for four seconds (Source LED’s turn ON).
3.
Enter the
24HR Time
for alarm (use
PRESET •
to separate Hours and Minutes).
4.
Press
ENTER
to complete (source LED’s turn OFF).
Example:
Press
5 and 6
+
6 • 30
+
ENTER
= alarm set for 6:30 AM
Press
5 and 6
+
18 • 30
+
ENTER
= alarm set for 6:30 PM
Clearing the Alarm for a Specific Zone
FIG. 76
Setting the System Clock on the Tango Audio Controller
FIG. 77
Setting Alarm In a Zone
FIG. 78
Clearing the Alarm For a Specific Zone
Press and hold buttons 5 & 6
Press ENTER to save
Enter alarm time (24HR)
simultaneously for 4 seconds
to enter Alarm mode
Press ENTER to save
Enter "00"
Press and hold buttons 5 & 6
simultaneously for 4 seconds
to enter Alarm mode
