Custom Button Installation
22
Metreau Keypads Instruction Manual
Custom Button Installation
Overview
With the exception of the DAS-MET-NUM, all Metreau keypads feature field-replaceable pre-printed buttons. This section describes
removing the original set of buttons and replacing them with custom buttons.
Removing Buttons
The easiest way to remove and replace buttons on the Metreau keypads is to place the keypad assembly (FIG. 11) face-down on a
flat level surface, so that the buttons stay in position until you are ready to remove them.
IMPORTANT:
Disconnect the power supply and all wiring connections before removing/replacing buttons on the Metreau keypads.
IMPORTANT:
Before touching the device, discharge the static electricity from your body by touching a grounded metal object.
The Faceplate is attached to the Mounting Plate via four plastic tabs (two on each side of the Faceplate, as shown in FIG. 11). It is
not necessary to remove the plastic faceplate from the Mounting Plate in order to replace buttons.
1.
The faceplate is attached to the mounting plate via four plastic tabs (two on each side of the faceplate, see FIG. 11). To remove
the faceplate, gently pry it from either side.
2.
Gently lift each button off of their mounting posts on the circuit board.
3.
Select the location of the custom buttons and gently snap them into place on the Circuit Board.
Be sure to note the orientation of the LED window on each button, to avoid accidentally mounting them upside down.
4.
Reattach the plastic faceplate.
Button Kits
Three different button kits, which accommodate most installations, are available for Metreau keypads:
Audio
SIRIUS, XM, IPOD, MP3, CD2, AUX2, DVD2, PC, FM.
Residential
LIGHTS, FAN, SHADES, HVAC+, HVAC -, UP, DOWN, TV.
Commercial
DISP, PROJ, VC, AC, HVAC, LIGHTS, SCREEN.
FIG. 11
Keypad assembly
Plastic Faceplate
Metal Mounting Plate
Circuit board
Plastic tab
Plastic tab
