Harman® • Absolute43-C Owner’s Manual_R9 • 2018 -___ • 06/20
4
3-90-00772C
A. Appliance Certification
B. Glass Specifications
This appliance is equipped with 5mm mirrored ceramic
glass. Replace glass only with 5mm mirrored ceramic glass.
Please contact your dealer for replacement glass.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class “PL” connector pipe.
A Harman
®
Outside Air Kit must be installed in a mobile
home installation.
NOTE:
This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-2004, ULC S628-93, (UM) 84-HUD
* Weighted average LHV efficiency using data collected
during EPA emissions test.
**Weighted average HHV efficiency using data collected
during EPA emissions test.
***A range of BTU outputs based on EPA Default Efficiency
and the burn rates from the low and high EPA tests.
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
This wood heater has a manufacturer-set minimum low burn
rate that must not be altered. It is against federal regulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
E. Electrical Codes
120
VAC, 60 Hz, Start 4.
0 Amps, Run
3.0
Amps
Notice
: This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with
National Electric Code ANSI/NFPA
70-latest edition
or the
Canadian Electric Code CSA
C22.1.
D. BTU & Efficiency Specifications
NOTE:
Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
1
1
Product Specific and Important Safety Information
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED
HOME FLOOR, WALL, AND CEILING/ROOF MUST BE
MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
!
NOTE:
Some generator or battery back-up systems may
not be compatible with the micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.
MODEL:
Absolute43-C Pellet Stove
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
0135PS039E, 0135PS032S
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-12, ULC-S627-00,
ASTM E 2515-11, ASTM E 2779-10
ELECTRICAL
RATING:
120 VAC, 60 Hz, Start 4.0 Amps,
Run 3.0 Amps
GLASS
SPECIFICATION:
5mm mirrored ceramic glass
The
Absolute43-C is Certified to comply with
2020 particulate emission standards.
EPA Certification Number:
126-18
EPA Certified Emissions:
.99 g/hr
*LHV Tested Efficiency:
82.3%
**HHV Tested Efficiency:
77%
***EPA BTU Output:
34,800 - 10,600
****BTU Input
44,200 - 14,100
Vent Size:
3 Inch
Hopper Capacity:
52 lbs
Fuel
Wood Pellet
