Harman 300i Wood Insert
11
For Installation In Masonry Fireplace Only
3-90-300101
Harman® • 300i Wood Insert Owner’s Manual_R13 • 2010 -___ • 04/15
Handle Installation
The door latch handle and the damper handle are left off for
shipping, and will need to be installed. Both handles and their
bolts are packaged in the hardware bag. The shorter bolt
(2-1/4") will be used for the damper handle, and the longer
bolt (2-1/2") is for the door handle. Insert the bolt through the
open end of the handle, then thread the bolt into the latch
or the damper drive arm. Tighten only hand tight to prevent
cracking of the wooden knob.
slide-assist rollers
The insert bottom is equipped with rollers to aid in moving.
There are two stationary rollers toward the rear of the
appliance, and one engaging roller in the front. To engage
the front roller for movement, you'll first need to remove the
lower base cover. As shown above, the cover is installed
with a screw at each end of it. Remove these screws using
a 5/16 socket or driver. Slide the cover toward the front and
set aside.
To engage the roller; begin by lifting the roller up and forward
in its brackets. This will get the roller in its ready position.
Lift the front of the insert body approximately 1/4 inch. If
needed, the front leveling bolts can be tightened in to lift the
insert. With the body raised, pull the roller down and hold it
forward to lock it in the down position. You will need to hold
the roller into place while the insert is lowered.
Once the insert is in place, lift the front of the body
approximately 1/4" and the roller will disengage when you
lower the body. It is up to you if you want to raise the roller
and lock it in to the disengaged position.
Lower
Base Cover
Front Roller
Leveling bolt
Locked position
Ready position
Roller
