27
PF100
Lighting A Fire Manually
Lighting the fire manually will not be necessary unless
the igniter in the burnpot fails.
Follow steps 1 through 5 of the instructions for
automatic lighting.
6.
Flip the Igniter Switch Down
into the
"MANUAL-LIGHT" position. See Fig. 55.
7. Open inner and outer ash doors as shown
in figs. 63, 64, 65, on page 30.
8. Fill burnpot with pellets as shown.
See Fig. 57. Only fill level with the front
edge. ( ------- DO NOT OVERFILL ------- )
9. Have matches or other ignition source
ready.
10. Apply starting gel as shown in Fig. 58.
NOTE:
Stirring the starting gel into the pellets usually
allows the fire to become established quicker.
CAUTION:
A vapor flash could occur if too much
time is allowed to pass before lighting the starting gel.
CAUTION:
Care must be taken not to get starting gel
on your hands or clothing. Serious burns could occur during
the lighting process.
CAUTION:
Never try to apply more starting gel to an
already burning fire, or a fire with smoldering pellets.
"NEVER USE GASOLINE, GASOLINE-TYPE
LANTERN FUEL, KEROSENE, CHARCOAL
LIGHTER FLUID, OR SIMILAR LIQUIDS TO
START OR "FRESHEN UP " A FIRE IN THIS FUR-
NACE. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE FURNACE WHILE IN USE".
Fig. 55
Fig. 56
Fig. 57
Fig. 58
Operation
Summary of Contents for PF-100 Furnace
Page 11: ...11 PF100 Fig 19 Venting Configuration Graph Venting ...
Page 35: ...35 PF100 Feeder Parts ...
Page 40: ...40 PF100 Testing Label ...
