Programming the Remote
Macro Programming
The Power button may be programmed
to send out a sequence of up to ten com-
mands when it is pushed. This enables
you to turn on a number of products,
and have a program source turn to a
favorite channel or any other command.
In addition, a separate set of macro com-
mand steps may be programmed for
audio devices and video devices.
To program a macro into the Power
button, follow these steps:
1. Press either the
AVR
button
b
to
program a Power macro for audio
devices, or the
SAT Device Control
Selector
c
to program a Power
macro for video devices, and the
Mute
button
`
at the same time until the
red light under the
Device Control
Selector
turns on and the
Program/
Command Indicator
a
.
• When you press the
AVR
button
b
in this step, the macro steps pro-
grammed will play back and operate
in the same fashion when the Power
button is pressed for the AVR, CD,
TAPE and AUX device selectors.
• When you press the
SAT Device
Control Selector
c
in this step,
the macro steps programmed will
play back and operate in the same
fashion when the Power button is
pressed for the SAT, TV, VCR and CBL
device selectors.
2. Press the
Power
button
d
.
3. Enter up to ten macro steps by pressing
the
Device Control Selector
c
for the device from which you wish to
have the command sent, and then the
function button for each step you wish
to enter. Note that pressing the
Device
Control Selector
to change devices
is considered one of the ten macro
steps available.
• To enter the “Power On/Off” com-
mand during macro programming,
press the
Mute
button
`
.
DO NOT
press the actual Power button.
• Note that the
Channel Up/Down
buttons
f
may
NOT
be used
during a macro program sequence.
4. When all steps, up to ten, have been
entered, press the
Channel Up
button
f
to enter the commands. The red
light under the Device Control Selector
will blink twice and then turn off.
Example:
To program your TV, Cable
Box and the AVR35 to turn on when
the Power button is pressed, first
press-and-hold the
SAT
c
and
Mute
buttons
`
until the red light
comes on under the
AVR
button.
Next, press the
Mute
button
`
to
enter the Power command for the
33
AVR35RDS 230 volt Rev (C) 9/28/98
AVR. Press the
TV Device Control
Selector
c
to select the TV mode,
and then press the
Mute
button
`
again, to select TV Power. Finally,
press the
CBL Device Control
Selector
c
followed by the
Mute
button
`
to select Cable Power.
Press the
Channel Up
button
f
to enter the commands.
After following these steps, each time
you press the
Power
button
d
,
after either the
SAT
,
TV
,
VCR
or
CBL Device Control Selector
c
has been pressed, the remote will
send the “Power On/Off” command.
Erasing a Power Button Macro
To remove a macro program, follow
steps 1, 2 and 4 above, but do not follow
step 3. For example, to erase the macro
for the video devices just entered, press
the
SAT Device Control Selector
c
and the
Mute
button
`
at the
same time until the red light under the
SAT
button turns on. Press the
Power
button
d
, and then press the
Channel
Up
button
f
. The red light under the
Device Control Selector
will blink
twice to confirm the data entry and then
turn off.
