32
ADVANCED FEATURES
Advanced Features
the AVR 220 is turned off. Once the unit is
turned off, the semi-OSD displays will remain
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED SELECT
menu as outlined
earlier, and press the
⁄
/
¤
Buttons
mq
as
needed, until the on-screen
›
cursor is next to
the
SEMI-OSD TIME OUT
line. Next,
press the
‹
/
›
Buttons
n
until the
desired time in seconds is displayed. Note that,
unlike most of the other options in this menu,
this is a permanent setting change and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
the
⁄
/
¤
Buttons
mq
until the on-screen
›
cursor is next to the desired setting or the
RETURN TO MENU
line and press the
Set
Button
o
. If you have no other adjustments
to make, press the
OSD Button
v
to exit
the menu system.
Full-OSD Time Out Adjustment
The
FULL-OSD
menu system is used to
simplify the setup and adjustment of the
AVR 220 using a series of on-screen menus. The
factory default setting for these menus leaves
them on the screen for 20 seconds after a
period of inactivity before they disappear from
the screen or “Time Out.” Time Out is a safety
measure to prevent image retention of the
menu text in your monitor or projector, which
might happen if menus were left on indefinitely.
However, some viewers may prefer a slightly
longer or shorter period before the Time Out
display.
To change the Full-OSD Time Out, you will need
to make an adjustment in the
ADVANCED
SELECT
menu (Figure 9). To start the
adjustment, press the
OSD Button
v
to
bring the
MASTER MENU
to the screen.
Press the
¤
Button
q
until the on-screen
¤
cursor is next to the
ADVANCED
line.
Press the
Set Button
o
to enter the
ADVANCED SELECT
menu (Figure 9).
At the
ADVANCED SELECT
menu
(Figure 9), make certain that the on-screen
›
cursor is next to the
FULL-OSD TIME
OUT
line by pressing the
⁄
/
¤
Buttons
mq
as needed. Next, press the
‹
/
›
Buttons
n
until the desired time is dis-
played in seconds. Note that unlike most of the
other options in this menu, this is a permanent
setting change, and the Time Out entry will
remain in effect until it is changed, even if the
unit is turned off.
If you wish to make other adjustments, press
the
⁄
/
¤
Buttons
mq
until the on-screen
›
cursor is next to the desired setting or the
RETURN TO MENU
line and press the
Set
Button
o
. If you have no other adjustments
to make, press the
OSD Button
v
to exit
the menu system.
31
31
