8
STEP 3
Locate
: Control Panel Assembly [5] and Burner
Chamber Assembly [4], two 1/4-20x1/2” Screw [1a]
(two remaining from previous step).
Tools needed:
Philips head screwdriver.
Procedure
:
•
Place the control panel assembly between the
front legs as shown. There are slots on the
control panel that fit around the legs and line up
with the screw holes.
•
Be sure all the tabs on the back side of the
control panel are captured around the legs as
shown below.
•
Insert the two remaining screws and tighten
them securely.
STEP 4
Locate:
Burner Chamber Assembly [4], three 1/4-
20x1/2” Screw [1a] from Hardware Pack - Blister
card.
Tools needed:
Philips head screwdriver.
Note:
Inspect the burner chamber prior to assembly
to make certain the burner tube is correctly over
the end of the valve as shown:
Procedure:
•
Align the burner
chamber
assembly [4]
underneath
the smoker as
shown. Do not
remove Control
Knob or loosen
the attaching
screws to align
the burning
chamber tube to the valve.
•
Place the body of the burner chamber assembly
so that it sits flush with the bottom of the cabinet.
The mounting holes and mounting tabs should
line up.
•
For each mounting hole, insert a 1/4-20x1/2”
screw [1a]. Secure the burner assembly with the
three screws from the inside of the cabinet.
•
Securely tighten all three screws.
(Factory fitted)
(Factory fitted)
Ignition wire
Thermocouple wire
connecting thread
HK0522 2 Door Gas Smoker-Manual_v45.indd 8
15
/
4
/1
9
2:40 pm
