HIPS SERIES PLATFORM SCALES
1-2
long with C2
®
on its end. The output of each cell is
2mV/V with 5 to 15 volts DC excitation.
Lower Frame
Assembly
The lower frame assembly is also bolted directly to
the load cell and serves as support and protection. It
comes equipped with four leveling feet, a shock load
set screw and corner overload adjustments. The cor-
ner overload adjustments have been factory set to bot-
tom out at approximately 75% of the scale capacity.
DO NOT change this adjustment. As in the upper
frame assembly the HI 1212PS/S and the HI 1318PS/
S lower frame is made of cast aluminum. The HI
1824PS and HI 2424PS lower frame is all stainless
steel.
Preassembly
Precautions
Do not
store or operate the scale out of its specified
temperature range.
Do not
store other equipment on the scale when it is
not in use or in storage.
Do not
allow a build-up of debris on, around or under
the scale.
Do not
set the scale in water or allow water to settle
around the scale. Provide Proper drainage.
Do not
let moisture get on or into any of the electrical
interconnections.
Do not
allow static or other electrical discharges
through the scale.
Do not
try to adjust the shock or over load stops.
Do not
try to remove the load cell or adjust the allen
set screws above or below the load cell.
Unpacking and
Assembly
The HIPS Series scales are shipped fully assembled
and only require adjustment of the leveling feet. If
there is any damage to the shipping container or to the
scale save, all the packaging material and file a report
with the shipper.
