HARDT
Responsive, Reliable Solutions
Page 16 of 18
CUS-013-0025-02
Weekly Inspection
Thoroughly inspect the venting components supplied with the rotisserie for signs of damage (dents, perforations,
etc). Replace with certified Hardt components if required. Ensure that the electrical cord, water and gas lines are
free from damage and kinks.
Material Cleaning Guidelines
5.3.1
Guidelines for Cleaning Glass Surfaces
Wipe off residues with a soft cloth or a paper towel.
Remove baked-on residues using a wooden or plastic scraper. Avoid using a metal scraper as it may
scratch the glass.
Surfaces may be cleaned using a soft cloth with mild soap and water. Alternately, a glass cleaning spray
with paper towels may be used.
Avoid scratching the surface of the glass.
DO NOT USE abrasive scouring powder or abrasive cleansers on the glass door, the lamp’s glass
shield and the control panel.
DO NOT USE metallic scouring pads.
DO NOT USE metal scrapers.
AVOID putting cold water or a cold damp cloth onto the hot glass as this may cause the glass to crack
and shatter
5.3.2
Guidelines for Cleaning Metal Surfaces
Wipe up spills and residues with a cloth or paper towel.
Remove baked-on residues using a wooden or plastic scraper. Avoid using a metal scraper on exterior
surfaces as it may scratch the metal finish of the rotisserie.
Surfaces may be cleaned using a soft cloth with mild soap and water. Alternately, a spray-on degreaser
may also be used but only on stainless steel surfaces following the handling procedure outlined on the
product label. Do not apply degreasers or other harsh chemicals to painted surfaces as this may
permanently affect the look and performance of the finish.
The look of stainless steel surfaces can be improved by using stainless steel polishing creams. Follow the
instructions on the packaging of the polishing product being used.
Avoid scratching or marring metal surfaces.
For stubborn build up
on the interior stainless steel surfaces of the oven (including around the door’s
opening), bristle brushes or mild scouring pads can be used. Refer to the daily cleaning laminates for
details.
DO NOT USE abrasive scouring powder or abrasive cleansers.
DO NOT USE metallic scouring pads.
DO NOT USE metal scrapers on exterior surfaces.
DO NOT USE corrosive cleaning agents.
