HARDT
Responsive, Reliable Solutions
Page 12 of 18
CUS-013-0025-02
Controller Functions
This section contains information for basic operation and programming of the Inferno GC system.
4.4.1
Buzzers and Alarms
(Press
STOP
once to end a buzzer. Press and hold
STOP
for 3 seconds to stop any action
except an AUTOCLEAN cycle.)
At the end of a preheat cycle when the correct temperature is reached, a buzzer sounds for 5
seconds and the yellow end of program light (Figure 3-1, Figure 3-2) turns on.
If the rotisserie temp
erature then drops below 150˚F [65.6˚ C], the red alarm lamp will flash and a
message on the controller display will prompt to repeat the preheat cycle.
At the end of a cooking cycle and of subsequent cook time additions, a buzzer sounds for 10
seconds and the yellow end of program lamp turns on.
In case of a Safety Lock Out (gas burner does not light), the red alarm lamp (shown in Figure 3-3)
will flash continuously.
4.4.2
Programming
The controls allow many of th
e rotisserie’s parameters to be accessed and modified. Only the basic
programming of “Favorites” is described in this manual. Additional modification of the parameters must be
performed by an authorized service technician. Please call Hardt Customer Service for further
information.
4.4.3
Programming Favorites
A Favorite is a shortcut to a cooking program. To assign a different cooking program to a Favorite button:
1. Hold
EDIT
and a single
FAVORITE
key simultaneously for three seconds.
(Display shows
“P0 / 7-8 SKS MANUAL”
).
2. Use the
PROGRAM UP
or
PROGRAM DOWN
buttons to locate any program in memory
from 1 to 16.
3. Press
ENTER
to save program selection to that Favorite button.
