Page 11
For technical questions, please call 1-888-866-5797.
Item 91062
SaFEty
OpEra
tiOn
MaintEnancE
SEtup
Depth adjustment
The Planer may be adjusted to cut to a depth of
up to 1/16
" per pass along the workpiece.
• To
increase
the depth of cut,
turn the Depth Knob
clockwise
.
• To
decrease
the depth of cut,
turn the Depth Knob
counterclockwise
.
• Return the Depth Knob to read “0” on
the Dial (23) when finished cutting.
nOtE:
For a rough-cut workpiece use a deeper cut,
but do not exceed 1/16". Once the workpiece
is planed smooth, make a number of shallower
cuts to acquire the desired depth.
Guide adjustment
The Guide controls the width of the cut from the edge of the workpiece.
1. Insert the Knob (79) through the upper hole in
the Angle Bracket (80) and thread it into the
hole in the Left Housing. See
Figure H:
.
2. Loosen the Guide Lock Knob (78) and
slide the Guide to the desired setting.
3.
iMpOrtant:
Retighten the Guide
Lock Knob after adjustment.
note:
The markings on the Guide are intended
as general guidelines only. For accurate
measurements, use a measuring tool to verify
the position of the Guide after tightening.
Guide Lock
Knob (78)
Guide
(83)
angle
Bracket
(80)
Knob
(79)
Figure H:
Dust Switch
The Dust Switch determines which Dust Port the dust blows out of.
1. Move the Switch towards the desired Dust Port.
note:
Do not position the Switch between settings or
the dust will come out of both ports.
2. Connect the supplied Dust Bag (77) or a different
dust collection system (not included) to the
Dust Port that the exhaust is being directed to.