Page 5
SKU 95916
for technical questions, please call 1-800-444-3353.
The rear section of the Blade is adjusted as follows: Hold the handle of the Blade
Guard (9) firmly while you remove the Adjusting Pin (8). Then, raise or lower the
Blade Guard (9) using one of the four adjusting holes and re-insert the Adjusting
Pin (8) at the height you need. See
figure 2.
noTe: To remove the Adjusting Pin (8) you will first need to remove the Pin Safety
Hook (10). Be sure to replace the Pin Safety Hook (10) after adjusting the height of
the Blade Guard (9). See
figure 2.
figure 3
Next adjust the Depth Gauge (16) by loosening the Adjusting Knob (15) at the rear
of the Base (14). Slide the Depth Gauge (16) in or out and re-tighten the Adjusting
Knob (15). Now each brick will set identically on the Brick Splitter. See
figure 3.
Raise the Handle (1) to it’s full height, slide the brick to be split into the opening
under the Blade (13). Be sure the brick is resting flatly on the Foam Pads (17) and
is against the Depth Gauge (16).
noTe: after loading the brick onto the brick splitter the task becomes a one
handed operation. keep your other hand off the brick splitter and completely
free of the operation until the brick is split and the handle (1) is raised again
to it’s full height.
3.
4.
5.
6.
figure 2
16
