SKU 94740
for technical questions, please call 1-800-444-3353. Page 6
AdApter storAge compArtment
Remove the Protective Cover (16) from the bottom of the Solar Lantern by pulling
down. Set the Cover aside.
See Figures 3 & 4.
Figure 3
Protective
Cover (16)
Protective
Cover (16)
Figure 4
AC Adapter
Bracket (13)
Wing Nuts (14)
Bottom Cover (1)
AC Adapter (15)
Unscrew the Bottom Cover (1) from the base of the Lantern.
Inside of the Bottom Cover (1) is the AC Adapter (15) held in place by the AC Adapter
Bracket (13). Remove the Wing Nuts (14). Set the AC Adapter Bracket and Wing
Nuts aside. Remove the AC Adapter. Use this Adapter in a household electric outlet
for charging the Solar Lantern.
See Figure 4.
After charging, fold up the wiring of the AC Adapter (15) and store in the Bottom
Cover (1), using the AC Adapter Bracket (13) to hold it in place. With the AC Adapter
Bracket in place, tighten the Wing Nuts. Thread the assembly back on the bottom
of the Lantern. Replace the Protective Cover (16).
See Figure 4.
1.
2.
3.
4.
inspection, mAintenAnce, And cleAning
wArning! Make sure the Power Switch (17) of the Solar Lantern is in its
“OFF” position and that the Adapter is unplugged from its electrical outlet before
performing any inspection, maintenance, or cleaning procedures.
before eAcH use, inspect the general condition of the Lantern. Check for loose
screws, cracked or broken parts, damaged electrical wiring, and any other condition
that may affect its safe operation.
do not use damaged equipment.
Clean the outside of the Lantern with a clean damp cloth. Never use abrasive clean-
ers; they will damage the unit. You may use a mild detergent. Never submerge
the Lantern in water or any other liquid.
Dust covering the Plastic Light Cover will
block out sunlight causing a decrease or stoppage of efficiency in recharging the
batteries.
1.
2.
3.
