923021011_09_00
4
Page
1
from
4
GENERAL
These luminaires are used in places
where emergency luminaires are needed.
Each luminaire must be permanently
c o n n e c t e d t o m a i n s p o w e r s u p p l y.
Internally, the product consists of 2
subsystems, 1 for each lamp. Each
subsystem contains 2 batteries that are
c h a r g e d a n d d i s c h a r g e d a n d a r e
i n d e p e n d e n t f r o m t h e o t h e r .
Due to this, each lamp lights with its own
b a t t e r i e s a n d t h u s d u r i n g a d e e p
discharge will go OFF at a slightly different
instance compared to the other lamp.
In the event of a power failure, the
luminaire will automatically light both
lamps. When the mains power supply is
restored the luminaire returns to normal
charging operation.
The perimeter of the TEST button contains
a green charge indicator. When the unit is
connected to the power supply and the
batteries are also connected, the green
indicator blinks to show that the batteries
are charging but are not fully charged.
When the batteries are fully charged then
the indicator stays ON continuously. On
every press of the TEST button and for as
long as the test is conducted, the indicator
w i l l b e O F F. I f t h e b a t t e r i e s a r e
disconnected the indicator will also be
turned OFF. In order to do a complete
duration test please be sure that the
indicator is continuously ON. If it is blinking
it is a sign of a power failure and that the
batteries are not fully charged. Let the
batteries charge until the indicator stops
blinking and then conduct the duration test.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation, maintainance
or testing must be done by authorized
personnel only
.
2. The device must be connected to the
mains power supply thr
o
u
gh
a fuse
dependent by the total amount of the line’s
power load.
3.
It is suggested to check every 6 months
the minimum autononous duration by
disconnecting the mains power supply
.
Count the time that the lamps light and in
case of less time than the minimum
autonomous duration the batteries must be
r e p l a c e d . I f t h e m e a s u r e d t i m e i s
considerably less than the minimum
autonomous duration
contact the installer.
Congratulations for your selection to buy this product.
Olympia Electronics - European manufacturers
.
WATERPROOF POWER LIGHT SERIES, NON MAINTAINED EMERGENCY LUMINAIRE
GR-21/Η3
TECHNICAL CHARACTERISTICS
220-240V AC/50-60Hz
3 ώρες
24
ώρες
From overcharge and deep discharge
IP 65
4
x12V/7Ah
1380lm
2
x55W (halogen
)
38W/ 47VA
EN 60598-1, EN 60598-2-22
, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
o
5 to 40 C
Up to 95%
Electrostatically
painted
metal plate
3 years
(1
year for the lamps and the battery
)
15.
71
Kgr.
405 x 130 x 500 mm
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Pb)
CHARGING TIME
BATTERY PROTECTION
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
EMERGENCY ILLUMINATION
LIGHT SOURCE
