SKU 65512
For technical questions, please call 1-800-444-3353.
Page 7
not completely discharge batteries.
Remove Battery Pack from tool, allow
it to cool, and charge for 3-5 hours,
making sure not to exceed 5 hours of
charging time.
When not charging, unplug Charger
6.
from outlet and store in secure loca-
tion.
Installing/Removing Saw Chain
use of any
accessory or
attachment other than those
listed below may increase the
risk of serious injury.
make sure Battery pack (1)
has been pulled out and
trigger (3) is “OFF” before
installing or removing Saw
Chain (10).
Use a screwdriver (not included) to
1.
loosen Pan Head Screws (23) and
remove Housing Cover (20). See
Figure B
, below.
Use screwdriver to remove Tip Guard
2.
(12) from end of Guide Bar (11).
Loosen the Head Bolt (19) with
3.
the Hex Wrench (2) and remove
the Guide Bar (11). See
Figure C
,
above.
Fit Saw Chain (10) over Guide Bar.
4.
please note:
The Saw Chain cutters
must face the directions shown by the
arrow below. See
Figure D
, below.
WARNINg!
5.
Wear ANSI-approved
safety goggles and heavy-duty work
gloves when adjusting or installing
Saw Chain.
Continue fitting the Saw Chain over
6.
the Guide Bar. Use the Hex Wrench
to fasten Guide Bar back onto Chain
Saw housing, making sure the con-
cave part of the Guide Bar touches
the Spring. Tighten Head Bolt (19).
Once the Guide Bar is fastened
7.
securely, replace the Housing Cover
and the Tip Guard.
Adjusting Saw Chain tension
Before initial use and after each
1.
subsequent use, check Saw Chain
tension.
Figure B
Pan Head
Screws (23)
Figure C
Hex Wrench (2)
Head Bolt (19)
Guide Bar (11)
Figure D
Guide Bar (11)
Saw Chain (10)
Saw Chain Cutter
Spring (8)
Tip Guard (12)
Housing Cover (20)
