SKU 65512
For technical questions, please call 1-800-444-3353.
Page 6
SpECIFICAtIONS
Voltage
18V DC
Charger Input
120 V~ / 60 Hz
Charger Output
20VDC, 400mA
Cutting Capacity
7”
Charging Time
5-6 hr.
Guide Bar Length
7”
Battery
NiCd, 1.2V, SC 1700mAh
Oil Capacity
4 oz.
Noise Level
88 dBA @ 3 ft.
uNpACKINg
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
SEt up INStRuCtIONS
Read the ENtIRE ImpORtANt
SAFEty INStRuCtIONS
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO pREVENt
SERIOuS INjuRy
FROm ACCIDENtAL
OpERAtION: turn the power
Switch of the appliance to its
“OFF” position and unplug
the appliance from its
electrical outlet before
assembling or making any
adjustments.
Note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Charging Battery pack
Charge Battery Pack (1) only with the
1.
18V charger provided. Charge in-
doors only. Allow time for the Battery
to cool before and after cooling.
Insert Battery Pack into Charger
2.
Stand (24). Plug Charger (25) into
appropriate AC 120V, 60 Hz power
outlet. See
Figure A
, above. The red
LED light on Charger Stand will acti-
vate, indicating battery is charging.
The initial charging time is 3-5 hours,
3.
after which the Battery Pack should
be removed.
please note:
The
green LED light will activate when the
Charger is plugged in, even without
the Battery Packet being installed.
The Red LED light will activate once
the Battery Pack is installed and
charging. The Red LED light will
NOT deactivate or changed color
when fully charged. Do not charger
for over 5 hours.
After each subsequent use, 3 hours
4.
of charging time is need for Battery
Pack to be full charged. However,
the Battery Pack can be left to charge
for 5 hours to ensure longer running
time for Chain Saw.
If the Battery Pack delivers an abnor-
5.
mal performance, discharge batteries
by holding Trigger (3) down in “ON”
position until Chain Saw slows. Do
Figure A
Battery
Pack
(1)
Charger Stand (24)
Charger
(25)
