Page 14
For technical questions, please call 1-888-866-5797.
Item 56814
Inspection and Maintenance
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Drone and Remote Control are OFF
before performing any procedure in this section.
1.
BEFORE EACH USE,
inspect
the general condition of the
Drone. Check for:
• loose, misaligned body shell
• bent motor shafts
• cracked or broken rotors
• any other condition that may
affect its safe operation.
2.
AFTER USE,
use a mild detergent
on a clean cloth to remove
any dirt from the Drone.
3. Contains Lithium-Polymer battery.
Battery must be recycled or disposed
of properly. Do not open, crush,
heat above 140° F or incinerate.
4. Remove batteries from Remote Control,
then store the Drone and accessories
in a dry area away from direct sunlight
and out of the reach of children.
Replacing Rotors
1. For the Drone to operate properly, the
Rotors must be installed in designated
locations as shown. Rotors are marked
A or B on the tops of the blades.
2. Remove screw holding the Rotor in
place using supplied screwdriver.
3. Lift Rotor and screw off Shaft.
4. Place new Rotor and screw on Shaft
and tighten screw securely.
CAUTION!
Guards near rotors must
stay in place and be undamaged.
A
B
B
A
A
B
B
A
Rotor Positions
