8
9
AA
AA
10
Lowes.com/harborbreeze
Lowes.com/harborbreeze
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Hardware Used
Wire Connector
x 4
AA
8
E
A
Slot
Tab
Yoke
7
D
H
12
C
B
11
B
A
Screw
9
Grounded/Green
Black
White
Grounded/
Green
Black
Blue
White
outlet box
blue black white green
white
GREEN/
black
Supply circuit
Speed
switch
GROUNDED
7. Re-tighten set screws in yoke, then slide the yoke cover
(D) down over the motor housing assembly (H).
8. Install hanger ball on the top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on the mounting bracket (A).
DANGER:
Be careful when aligning the tab to the
slot. If not fully engaged, the fan could fall, which could
result in serious injury or death.
9. Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire from ceiling. Connect
WHITE
wire
from fan to
WHITE
wire from ceiling. Connect all
GROUNDED
(GREEN)
wires from fan to
GREEN
wire from ceiling.
Note: BLACK
wire is hot power for fan.
BLUE
wire
is hot power for light kit.
WHITE
wire is common
for fan and light kit.
GREEN
wire is grounded wire.
If house wires are different colors than referred to
above, stop immediately and consult a
professional electrician to determine proper wiring.
10. Twist wire ends together and screw wire connectors
(AA) on in a clockwise direction. Tape wire connectors
(AA) and wires together with electrical tape (not
included).
Note:
Wires should be spread apart with grounded
conductor and equipment-grounding conductor on one
side of outlet box and ungrounded conductor on other
side. After making connections, make sure bare wire or
wire strands are NOT visible.
Place
GREEN
and
WHITE
connections on opposite side
of box from
BLACK
and
BLUE
connections. Splices
should be turned upward and pushed carefully up into
outlet box.
11. Slide canopy (B) up to ceiling and over two screws on
the mounting bracket (A). Rotate canopy (B) to lock it
into place. Securely tighten screws.
12. Slide the canopy cover (C) over the two screws and
rotate clockwise until it locks.
Note:
Adjust the screws as necessary until the canopy
(B) and the canopy cover (C) are snug.
