6
7
ASSEMBLY INSTRUCTIONS
1
4
5
A
Clip
Pin
E
B
6
Set screw
Screws
Plastic Stabilizer
E
Clip
Yoke
Pin
Lowes.com/harborbreeze
Lowes.com/harborbreeze
A
B
3
H
D
2
ASSEMBLY INSTRUCTIONS
Outlet box
H
H
3. Remove and discard the four screws securing the
plastic stabilizer on top of the motor housing. Remove
and discard the plastic stabilizer.
4. Remove preassembled pin and clip from downrod (E).
Save for later use.
5. Insert downrod (E) through canopy (B), canopy cover
(C) and yoke cover (D). Thread wires from motor
housing assembly (G) through downrod (E).
6. Loosen preassembled set screws from the yoke on
motor housing assembly (H). Slip downrod (E) into
yoke, aligning holes on both parts. Insert previously
removed pin through holes on yoke and downrod (E),
then insert previously removed clip into the pin until it
snaps into place.
1. Determine mounting method.
A-Downrod Mount (standard or angled ceiling)
B-Angle Mount (standard ceiling only)
IMPORTANT:
If angle mounting, check to make sure
the ceiling angle is not steeper than 20°.
2. Install mounting bracket (A) to outlet box (not included)
by sliding the mounting bracket (A) over the two outlet
box screws (not included). Securely tighten the two
outlet box screws.
IMPORTANT:
If angle mounting, make sure open end
of mounting bracket (A) is installed facing the ceiling.
C
B
D
E
