Harbor Breeze HTE22025, Manual

Page: 9 / 20

9
WIRING INSTRUCTIONS
2. Follow steps below to wiring your fan.
WARNING:
To avoid possible electrical shock, be sure electricity is turned off at the main fuse
box before hanging.
WARNING:
If you are not sure if the outlet box is grounded, contact a licensed electrician for
advice, as it must be grounded for safe operation.
WARNING:
If house wires are different colors than referred to in the following steps, stop
immediately. A professional electrician is recommended to determine proper wiring.
WARNING:
If you feel that you do not have enough electrical wiring knowledge or experience,
have your fan installed by a licensed electrician.
2
Blue
）
Orange
(UP LIGHT)
Orange
(UP LIGHT)
Blue
（
（
DOWN LIGHT
DOWN LIGHT
）
TO MOTOR N from the receiver.
UP LIGHT from the receiver.
ORANGE ORANGE
1. To sync the remote from remote unit (K) to the receiver
also in remote unit (K), first remove the battery cover from
the remote and slide code switches to your choice of up or
down position using a small screwdriver or ballpoint pen
(neither included).Replace battery cover on remote. Then,
slide the code switches on the receiver to the same
positions as set on the remote.
Note:
Factory setting is all up; do not use this position.
ON
1 2 3 4
DIP
1
DIP
ON
Remote
Receiver
WHITE WHITE
Connect BLUE wire from the fan to BLUE wire marked
DOWN LIGHT
from the receiver.
Connect BLACK wire from the fan to BLACK wire marked
TO MOTOR L from the receiver.
Connect BLACK wire from the outlet box to BLACK wire
marked AC IN L from the receiver.
Connect WHITE wire from the outlet box to WHITE wire
marked AC IN N from the receiver.
BARE COPPER) from house.
GROUND (GREEN)
bracket and downrod ball, to GROUND (GREEN or