8
CAUTION:
Ensure all screws are tight before moving
6 to 9in
onto the next step.
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
3. Cut off excess fixture wires, leaving approximately 6 to
9 inches above the top of the downrod assembly (B).
Strip 1/2 inch of insulation from the end of each fixture
wire.
4. Carefully lift the assembly and rest the hanger ball of
downrod assembly (B) on the mounting bracket (A)
attached to the outlet box. Be sure the groove in the
hanger ball is lined up with the tab on the mounting
bracket (A). This will allow for hands-free wiring.
Proceed to
WIRING
on page 9.
DANGER:
Be careful when aligning the tab to the
groove ! If not fully engaged, there is a possibility of the
fan falling, which may result in serious injury or death.
3
A
B
B
4
Hanger Ball
Groove
Tab
Summary of Contents for HTE22025
Page 5: ...5 WARNING CAUTION PREPARATION Estimated Assembly Time...
Page 20: ......
