7
Lowes.com/harborbreeze
1. Place downrod assembly (D) through canopy (B) and
canopy cover (C).
INITIAL INSTRUCTIONS
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
4. Remove the hairpin clip (P) and clevis pin (O) from the
coupling (E) preassembled on motor housing (H).
Retain for later use.
3. Check existing outlet box (not included) to ensure it is
securely fastened to at least two points in a structural
ceiling member and can support the full weight of the
fan. Once verified, install mounting bracket (A) to the
outlet box using the screws and washers provided with
the outlet box.
Loosen the two screws preassembled in coupling (E),
but do not remove them.
For
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
,
proceed to Step 1 below. For
FLUSHMOUNT
INSTRUCTIONS
, skip to page 9.
3
Open End
A
A
Note:
If using the angle mount, make sure open end of
mounting bracket (A) is installed facing the higher point
of the ceiling.
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation.
DANGER:
A loose outlet box can cause the fan to wobble
and increase the fan's potential to fall, which could result
in serious injury or death.
B
C
D
1
4
P
P
H
O
Screw
E
