12
FINAL INSTRUCTIONS
Lowes.com/harborbreeze
4
I
Screw
Hardware Used
x 10
CC
Motor Screw
3. Remove the 5 motor screws (CC) preassembled at the
bottom of motor housing (H), discarding the
preassembled motor blocks but retaining the motor
screws (CC) for later use.
Position one completed blade assembly under motor
housing (H). Align the holes on the motor housing (H)
and blade iron (F), then adjust the slot on the
preassembled mounting plate (I) over the holes. Using
2 previously removed motor screws (CC), insert
them through the slot on the mounting plate (I) into
blade iron (F) and motor housing (H), and partially
tighten. Repeat for the remaining blade assemblies by
using the previously removed motor screws (CC) as
well as those in the hardware pack, then securely
tighten all motor screws (CC).
5. To install the light kit (J), attach the connector
preassembled on light kit (J) to the connector
preassembled on motor housing (H).
Note:
The two connectors have keyholes that must be
mated correctly before they can be engaged.
4. Remove three screws preinstalled on the mounting plate
(I) and save them for later use.
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation.
To install the fan with the light kit (I), proceed to step 5
below. If you wish not to install the light kit (I), skip to
step 8 on page 13.
5
J
H
9-pin
connections
CC
CC
F
H
I
Motor Block
3
