Locate two canopy mounting screws (S) on
underside of mounting bracket (C) and remove
canopy mounting screw (S) closest to the open end
of the mounting bracket (C). Partially loosen the
other canopy mounting screw (S). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (S) in mounting bracket (C) and push up.
Twist canopy (B) to lock. Re-insert canopy mounting
screw (S) that was removed, and then tighten both
canopy mounting screws (S). Slide canopy cover
(G) up to canopy (B), aligning rounded part of
slotted holes in canopy cover (G) with screwheads
in bottom of canopy (B). Turn canopy cover (G) to
the right (clockwise) until it stops.
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire.
WARNING
: Make sure no bare wire or wire
strands are visible after making connections. Place
GREEN and WHITE connections on opposite side of
box from the BLACK and BLUE (if applicable)
connections.
Turn spliced/taped wires upward and gently push wires
and wire connectors (CC) into outlet box.
2.
IMPORTANT
: Using a full range dimmer switch (not
included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire or
electrical shock, do NOT use a full range dimmer
switch to control fan speed.
3.
WIRING
Wire Connector x 4
Hardware Used
CC
Dimmer
Switch
Speed
Switch
For illustrative purposes only
--
not
intended to cover all types of controls
2
3
1
2
3
CC
CC
CC
FINAL INSTALLATION
11
Lowes.com/harborbreeze
1.
1
G
S
B
