10
Lowes.com/harborbreeze
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
4. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner: Take
the lead wires and make sure you have pulled them
all the way through the top of the downrod. Measure
8 inches of lead wire, then cut the excess wire off with
wire cutters (not included).
5. If you decided to cut back the lead wire in Step 4, strip
1/2 in. of insulation from the end of the white wire.
Twist the stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat this
step for black, blue and green wires.
Important:
If you did not cut back the lead wires in
Step 4, Step 5 is not necessary and you may proceed
to Step 6.
6. Install the ball end of the downrod (A) into the opening
of mounting bracket (E). Align one of the four slots in the
ball with the tab in the mounting bracket (E).
Note:
Downrod should not rotate if installed correctly.
DANGER:
Failure to align the slot in the
downrod ball with the tab on the mounting bracket (E)
could cause the fan to fall, resulting in serious injury
or death.
Proceed to the
Wiring
on
page 12.
4
5
6
A
A
E
E
Tab
Slot
