ASSEMBLY INSTRUCTIONS
5. Wrap electrical tape (not
included) around each wire
connector (AA) down to
the wire. Then, push wire
connections into the outlet
box. Place the White wire
connections on the opposite
side of the outlet box from
the Black and Blue wire
connections.
8
9
5
6
7
12
10
11
High
LED Indicator
AA
CC
B
F
H
F
BB
C
F
A
C
High
OFF
Standard
Style
Decor
Style
Back
H
arbor Breez
e
H
arbor Breez
e
1. Use existing pull chains on the
desired fan to set fan speed to
high and to turn the light on.
2. Turn off circuit breakers and wall
switch to the fan.
DANGER:
Failure to
disconnect power supply prior to
installation may result in serious
injury or death.
3. Lower the canopy of the
previously assembled fan and
insert receiver (D).
Note:
If
installing this product with a new
fan, insert the receiver (D) in the
mounting bracket before wiring
the fan; wire the fan according to
these instructions, then continue
fan assembly as directed in the
fan’s instruction manual.
2
1
3
4. Disconnect
existing wire
connections, then
secure all wire
connections with
wire connectors
(AA) and push-on
connectors (E)
according to
diagram and
these steps:
Fan Pull
Chain
Light Pull
Chain
Black (hot/power)
White (neutral)
Whit
e
White
White
Black
Blac
k
Blue
Blue
Black
Antenn
a
4
• Connect the Blue wire with white label from the receiver
(D) to the Blue fan wire.
• Connect the Black wire with white label from the
receiver (D) to the Black fan wire.
• Connect the White wire with white label from the receiver
(D) to the White fan wire.
• Connect the Black wire with red label from the receiver
(D) to the Black (hot/power) supply wire.
• Connect the White wire with red label from the receiver
(D) to the White (neutral) supply wire.
D
D
AA
E
6. Reinstall the canopy.
7. If desired, the wall bracket
(B) can be attached to a
wall using the mounting
screws (CC). Slide small
plate over mounting
screws, then rest the
remote in the wall bracket
for easy storage.
8. Remove the battery cover
from the back of remote (A)
and install an A23 12-volt
battery (C). Replace the
battery cover and press the
High button to ensure the
LED indicator illuminates
and the fan turns on.
9. Select the adapter plate
that corresponds to the
style of wall switch to which
the wall control (F) will be
mounted -- decor plate (G)
or standard plate (H). Then
snap the plate into the back
of the wall control (F).
10. Remove the two screws
from the wall switch to
which the wall control (F)
will be mounted. With door
to wall control (F) open, use
the two plate screws (BB)
to attach the wall control (F)
to the switch plate.
11. Insert the remaining A23
12-volt battery (C) into the
battery compartment of wall
control (F). Press the High
button to ensure the LED
indicator illuminates and the
fan turns on.
12. Turn on power to wall
control and ceiling fan.
