11
ASSEMBLY INSTRUCTIONS
OPTIONAL:
If desired, the wall bracket in
remote pack (J) can be installed to house
the remote control. Remove the small plate
preassembled on the wall bracket and use the
screws in remote pack (J) to secure the wall
bracket at desired mounting location. Replace
the small plate, then rest the remote control
from remote pack (J) into wall bracket.
13. Align the three flat areas on the top flange of
the glass (G) with the three raised dimples in
the light fixture (F). Insert the glass (G) into
the light fixture (F), then turn the glass (G)
clockwise until it stops.
Raised
dimples
Flat area
F
G
13
10
CAUTION:
Avoid touching the LED with
your bare hands. Be sure the power is off
and the glass and LED are cool before
cleaning the fixture.
OPERATING INSTRUCTIONS
1. Install Battery/Learning Process:
Remove the battery cover from the back of the remote
found in the remote pack (J). Insert the battery from the
remote pack (J) into the remote; ensure polarity of battery
matches the polarity indicated in the battery compartment
-- positive (+) to positive (+) and negative (-) to negative (-).
Replace the battery cover.
If you need to change the dip switches in the remote control
due to a potential interference issue, slide the dip switches
to your choice of either up or down -- the factory setting
is up. Within 30 seconds of turning the fan’s power on,
press and hold the “Learn” button on the remote control
for 1 second. Once the receiver has detected the set
frequency, the light of the fan will blink twice. Replace the
battery cover. To confirm the remote control and receiver
have paired successfully press any of the fan speed control
buttons on the remote control.
2. Fan Speed Control/Dimmer:
REMOTE CONTROL:
NOTE:
If you have more than one remote controlled fan installed in the same location, you may
want to change the frequency of the remote control to avoid any possible interference between
remote controls. To change the frequency of the remote control, change the dip switch settings as
described below:
Learn key
Dip switch
0 Low speed
0 0 Medium speed
0 0 0 High speed
O Turns fan off
Turns light on or off
NOTE:
For the DIMMER function, press and hold the light
button. Light will dim. Release the button when light is at
desired level.
NOTE:
This remote control has a memory function. The
receiver stores the fan speed and light setting when the fan is
turned off. When fan is turned on again, it starts with the most
recent settings.
3. Reverse Switch:
When the season changes ,you may want to change the
direction the fan blades spin. To switch between clockwise
and counterclockwise rotation, flip the fan reversal switch.
Sun
icon
Snowflake
icon
WARNING
: Wait for fan to stop before reversing switch.
• In warmer weather, counterclockwise rotation creates a
downward airflow, which cools the air. Push the switch
LEFT and see a Sun icon.
• In cooler weather, clockwise rotation creates an upward
airflow, which moves hot air from the ceiling into the
room. Push the switch RIGHT and see a Snowflake icon.
Small plate
Wall
bracket
Screws
