10
ASSEMBLY INSTRUCTIONS
U
INSTALLATION OF LAVA ROCKS AND LOGS
Unpack and put the lava rocks on ground. Pick up the solid lava rocks then layer them in level
across the burner bowl. Do not completely cover burner element or block the igniter box with
lava rock. Next, install the imitation fire logs. These should be laid in as shown in the image
below. Start by laying one log in the centre of the unit. This log should be perpendicular to the
igniter box. Lay the other logs, in a teepee configuration over the first log. It is important that the
logs not lay directly on top of the burner. By blocking the burner it will impact air flow and will
cause the unit to be difficult to ignite or will impact how the flame comes through and burns.
Once all the logs are in place as shown you can begin next steps.
NOTE:
Be sure unit is cool
before touching any of the components.
NOTE:
When first use, preheat the lava rocks and logs
for 15 minutes to burn out the impurities and air in the natural lava rocks and handmade logs.
SR2201BI/I2+ & SRR2201BI/I2+:
