Pr
ogr
ammable T
emper
atur
e & Humidity Contr
oller
40
Digit
al Mold Contr
oller
■
11. Pre-Heating
◈
Overview of Pre-Heating
◈
Start and finish Pre-Heating
◈
Conditions for start of Pre-Heating
▶
Pre-Heating is a function for freeze protection in winter target value for pre-heat
can be set in Pre-heat SV" on Control screen during pre-heating process, ON/OF
control is conducted according to pre-set "Pre-heating SV" (Initial value: 15C).
target value for pre-heat can be set in Pre-heat SV" on Control screen.
■
12. Control sensor conversion
▶
You can connect 4 temperature sensors together (Mold, MEDI, RETURN, ENTER).
▶
"MEDI sensor" and "MOLD sensor" is for control.
▶
"RETURN sensor" and "ENTER sensor" is for monitoring you can check
temperature in "CONTROL" --> " TEMP.DISPLAY".
▶
Select whether to use "MEDI sensor" and "MOLD sensor" by using "MOLD" key.
▶
It is set to "MEDI sensor" by default. If pressing MOLD key, "MOLD" LED flashes
and mode changes to "MOLD sensor"
▶
You can start and finish Pre-Heating by "PRE-H" key or communication
during pre-heating operation, press "RUN/RESET" key to stop pre-heating and
immediately start operation. However, if there is reservation, pre-heating
continues till reserved time.
▶
Pre-Heating cannot start during operation or SUCTION.
▶
Pre-heating can be operated during Forced COOLING or Manual Control mode.
however, be cautious as the priority for output is on Forced COOLING and Manual
Control.
Summary of Contents for MT100
Page 1: ......