Hanwha Vision LRN-1610S, User Manual

Page: 43 / 83

English _43
● menu setup
tampering detection
You can set up an event signal when camera tampering is detected, such as when the screen is obstructed or
the camera location is changed.
• Enable tampering detection : Check the box to set the tampering detection.
• Sensitivity : Sets the tampering detection sensitivity.
• Apply to CH : If you select < Apply to Ch >, the " Apply to Ch " confirmation window will appear.
After selecting channels that the settings will be applied to, click on < OK > to apply them to the selected
channels.
` Since tampering detection is designed for optimal performance based on the sensitivity level by the user, there may be no
noticeable change in the tampering detection performance depending on the sensitivity level under normal monitoring
conditions.
Video Loss Detection
You can set the camera so that the camera can trigger the alarm if it is disconnected or the video is lost due to
unstable network connection.
menu > event > Video Loss Detection
• Apply to CH : If you select < Apply to Ch >, the " Apply to Ch " confirmation window will appear.
After selecting channels that the settings will be applied to, click on < OK > to apply them to the selected
channels.
• CH : Click < > to display the channel information table.
• Video Loss State : Specify the use of video loss detection.
• Alarm Out : Select an alarm output method.
`
For alarm output, see the " HDD Alarm Setting " in " Menu Setup > Setting the Device " in the Table of Contents.
• Alarm Duration : Specify the duration of the alarm output with the beep.