Page EN-26
Installation, connection and initial commissioning
3. Hold the Start/Pause button
(6) in until
the displays
(13) and
(14) blink alter-
nately.
The display (8) will show the current de-
gree of hardness (
H1
to
H6
),
4. Push the start/pause button
(6) as
many times as required to display the re-
quired hardness level.
5. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Switch the dishwasher on using the but-
ton (1).
The display (8) initially shows all notifica-
tions. After a short time, the programme
symbol (10) for the ECO programme will
light up.
4. Start the programme with the button
(6).
The programme will begin after a few sec-
onds.
5. Ensure that no water comes out and no
unusual sounds are emitted.
6. After the programme has ended, an
acoustic signal will sound 8 times.
Switch the dishwasher off using the but-
ton (1).
7. Slightly open the door to allow the moist
air to escape more effectively.
8. Close the valve.
If no water has escaped and no unusual nois-
es have been heard, the dishwasher is ready
for operation and you can add the detergent
and put dishes into the dishwasher.
WARNING!
Risk of poisoning!
Dishwasher detergents, rinse aid and
dishwasher salt can be damaging to
the health.
■
Keep these products out of the reach
of children and pets.
■
Do not use water from the dishwash-
er as drinking water.
