Page EN-28
Troubleshooting table
Problem
Possible cause
Solution
The display
(13)
lights up although
dishwasher salt
has been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
The water is not
running or it is
running only very
slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such a manner
that it is not kinked.
The water tap is not proper-
ly on.
Turn the water tap on completely.
The water is not
running off or only
very slowly.
The filters are blocked.
Clean the filters (see page EN-20).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the proper man-
ner (see page EN-22).
The dishwasher is
not watertight.
The door seal is defective. Have the door seal replaced (see „Service“
on page EN-30).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced (see
„Service“ on page EN-30).
The dishwasher
can be switched
on/off, but not can-
not be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
Error messages in the display
Code
Solution
E1
:
It takes too long for
the water to fill up.
Turn the water tap on completely.
Lay out the inlet hose in such a manner that it is not kinked. See (see
„Connecting the inlet hose“ on page EN-23).
Ensure that the water pressure is correct. See (see „Technical specifica-
tions“ on page EN-31).
E4
:
Water overflow
Switch off the tap. Find the gap in the seal (or have someone find it) and
repair the leak (or have it repaired).
