Page EN-26
Installation and connection
ings (b). Remove the required number of
moulding from the block. To do so, move
the moulding vigorously but without using
tools.
4. Clamp the moulding under the control
panel.
(f)
5. Pull the two Velcro straps (f) apart.
6. Remove the protective film from the same
Velcro strap.
(f)
7. With the protective film removed, stick the
Velcro straps (f) onto the middle of the re-
cessed areas on the dishwasher door.
8. Cut the positions of the Velcro straps out
of the drilling template.
9. Cut the number of mouldings used off the
drilling template.
(f)
10. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
11. Transfer the drill holes from the drill tem-
plate to the front panel.
12. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
13. Remove the protective films from the
other velcro straps and stick the velcro
straps to the front panel using the drilling
template.
14. Fix the front panel to the dishwasher
door using the Velcro straps (f). Hold
the front panel firmly and open the door
carefully.
(i)
Summary of Contents for WQP12-7735B
Page 36: ......
