Page EN-28
Installation and connection
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the ap-
pliance functions perfectly. Carry out this test
run when the dishwasher is empty and with-
out any dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a short period of time, the LED pro-
gramme
ECO
will light up.
4. Press the
P
(9) button as often as re-
quired until the LED behind the pro-
gramme symbol
illuminates.
5. Start the programme using the button
(10).
The programme will begin after a few sec-
onds.
6. Be careful of escaping water and unusual
sounds.
7. You will hear an acoustic signal at the end
of the programme.
Switch the dishwasher off using the but-
ton (1).
8. Open the door a little to allow the moist
air to escape.
9. Close the valve.
If no water has escaped and no unusual nois-
es have occurred, the dishwasher is ready for
operation and you can add the detergent and
put dishes into the dishwasher.
Summary of Contents for WQP12-7735B
Page 36: ......
