Page EN-16
Washing process
Requirements
– You have read the chapter “Safety” from
page EN-4 and understood all safety in-
structions.
– The transportation packaging is removed
and the appliance is prepared as described
in chapter ‘Set up and connection’ on
page EN-25.
– The water inlet hose (b) and water outlet
hose (12) have been properly affixed.
Starting the cycle
Startzeit-
vorwahl
Start /
Pause
Funktionen
Anzeige
Aus
Spülen
Allergie
Hand-/
Feinwäsche
Mix
Kurz 60'
Extrakurz 15'
Baumwolle
40°C
4
Baumwolle
60°C
Jeans/
Dunkle Kleidung
Sport
Schleudern/Abpumpen
//
(2)
(3)
(4) (6)
(5)
(7)
(7a)
un
n
u
n
n
1. Select the desired wash cycle using the
cycle selector (2).
2. Make changes if necessary:
– To adjust the
water temperature
, press
the Temp. button (4) repeatedly until the
desired value is shown in the display (3).
– To adjust the
spin speed
, press the Spin
button (5) repeatedly until the desired
value is shown in the display (3).
3. Open the valve completely.
4. Press the Start/Pause button (7).
– The cycle starts.
– The LED cycle (7a) stays on.
– The remaining cycle time is shown in the
display (3).
– The door is locked.
Suspending and continuing
the cycle
Please note that a long pause can affect the
wash result, as the soapy water cools down.
• If you want to stop the cycle in progress,
for example, to put in additional washing,
press the Start/Pause button (7).
The cycle LED (7a) will flash during the in-
terruption.
Depending on the cycle’s progress, the
door will either be released or remain
locked.
• Press the Start/Pause button (7) again to
continue the cycle.
Suspending/altering the cycle
1. Turn the cycle selector (2) to Off to inter-
rupt a cycle in progress or to select anoth-
er cycle.
This will stop the cycle.
2. Use the cycle selector (2) to select any
cycle.
The soapy water will now be drained.
3. Use the cycle selector (2) to select a new
cycle and add detergent if required.
4. Press the Start/Pause button (7) to start
the new cycle.
Cycle end
The appliance stops automatically as soon as
the selected cycle is finished. ‘End’ will now
be shown in the display (3).
1. Turn the cycle selector (2) to Off.
2. Once the locking time has completed af-
ter approx. 2 minutes and you hear a click
releasing the door, you can then remove
the laundry.
3. Leave the loading door open and pull the
dispensing drawer (1) out slightly to allow
the inside of the appliance to dry.
4. Turn off the tap and take the mains plug
out of the wall socket.
Washing process
