Start-up
Page EN-40
Extending the appliance hose
You will need these parts to extend the white
appliance hose (56):
(51)
1× Safety clip
(57)
1× Extension hose,
blue, 6 m
(56)
(57)
(55)
(58)
1. Remove the cap (55) from the white ap-
pliance hose (56) and insert the end of
the appliance hose into the hose coupling
(58) on the extension hose (57) until it
makes contact.
(51)
2. Fix the extension hose in place using a
safety clip (51).
3. Close the water filter (43) as described in
section "Connecting the appliance to the
water supply“ on page EN-40. Follow steps
3 to 5. Instead of using the white appli-
ance hose, now use the blue extension
hose.
Connecting the appliance to
the water supply
NOTICE
Risk of water damage!
Faulty assembly of the water connec-
tion can result in water damage.
■
The appliance’s water pressure is set
at 2–7 bar. For higher water pressure,
a pressure regulator needs to be in-
stalled. If in doubt, enquire about the
water pressure with the water supply
company.
■
Do not connect the appliance to the
tap or mixing arm of a water heat-
er (e.g. continuous flow heater, pres-
sure-free boiler, etc.).
■
Ensure that the hoses are not kinked
and are carefully connected.
■
Do not extend the inlet hose included
with the delivery if it is too short. In
this case, contact our service depart-
ment (see page EN-45).
■
Do not use old or previously installed
hoses.
You will require a valve with a ¾-inch screw
connector for the water supply.
1. Make sure that the water supply is closed.
(53)
(54)
(51)
2. Push the inlet hose (54) into the ¾-inch
screw connector (53) and affix the inlet
hose with a safety clip (51).
