Start-up
Page EN-28
(28)
4. Level out any unevenness on the ground
using the two front screw feet (28).
– Close the doors to do this.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
Adjusting the doors
It may be that the doors are not on the same
height, even if the fridge-freezer itself is com-
pletely level.
In this case, you can adjust the position of
the doors by lowering or lifting the door to the
fridge.
NOTICE
The doors can be adjusted by a maxi-
mum of 5mm.
1. Open the door to the fridge wide.
(29)
(30)
lower
lift
2. Turn the locknut (29) two full rotations
clockwise to loosen it. Use the spanner
supplied to do this.
3. Turn the adjusting nut (30) in the desired
direction until the doors are on the same
level.
4. Tighten the locknut (29) again by turning it
anticlockwise.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before using
it (see "Cleaning the fridge“ and "Cleaning the
freezer“ on on page EN-23).
