Start-up
Page GB-17
To achieve the highest possible cooling per-
formance with the least energy consumption,
choose a location that:
– is not too warm, is dry and well ventilated,
– is not in direct sunlight,
– measures at least 10 m
3
.
We do not advise placing it directly next to
an oven, stove or radiator. The minimum dis-
tances to such appliances are:
– from electrical hobs
3 cm
– from oil and coal burning stoves
30 cm
– from refrigerators
2 cm
– from washing machines/dishwashers 2 cm
If these distances cannot be maintained,
place an insulating plate in-between. If un-
derfloor heating is installed in the room where
the mini refrigerator is to be installed, place an
insulating plate of solid material underneath.
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible. In doing so, ensure
– that the entire space above the appli-
ance is clear;
– that there is adequate wall clearance.
Leave space of at least 3 cm.
(7)
(7)
2. If necessary, screw the spacers (7) into
the threads at the rear.
3. Check the position with a spirit level.
(3)
If the appliance is not positioned securely,
4. Close the doors.
5. Tilt the appliance backwards slightly.
6. Screw/unscrew the screw-on feet (3) until
the appliance is level.
7. Reposition the appliance upright.
8. Check the alignment with a spirit level.
The appliance should not move when
opening the doors.
Removing the polystyrene
block
1
0
5
4
3
2
(9)
(10)
(8)
Between the compressor (10) and bottom of
the cooling compartment (9) there is a poly-
styrene block (8) which is there to protect the
compressor against vibrations during trans-
port. You must remove it before start-up.
