Hanseatic HKS12851FB, User Manual

Page: 57 / 64

4. Tip the appliance backwards and bring it
into a horizontal position.
(13)
(14)
5. Screw the enclosed support leg (13) to
the bottom edge of the appliance door us-
ing the enclosed screw (14).
Cleaning before use
To remove the odour which is present in all
new appliances, wipe the interior with dilut-
ed vinegar prior to first use. Then wipe it out
with clean water and dry all of the parts off
afterwards.
Commissioning the appliance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
it starts smoking or there is a smell
of burning,
–
it makes unfamiliar noises.
In such cases, pull out the mains
plug or unscrew/isolate the fuse and
contact our service department (see
page EN-29).
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; consult
a qualifi ed professional if necessary
(see “Service” on page EN-29).
■
Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
mproper handling of the appliance can
lead to fi re and property damage.
■
Only connect the appliance to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may make its way into
the cooling circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
Start-up Page EN-25