Hanseatic HGT128A, User Manual, Page: 45 / 62

Operation Page EN-13
Switching on again
If the running operation has been interrupted,
the freezer can not be restarted immediately.
It is interrupted,
– if you set the temperature controller (3) to
“OFF”.
– if you unplug the mains plug from the sock-
et.
– in the event of a power failure.
• Wait 4 to 5 minutes before restarting the
chest freezer.
If the lid of your freezer does not open
again after closing, it has formed a vac-
uum inside. Wait for 1 to 2 minutes, and then
the lid can be easily opened again.
Temperature control
CAUTION
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Observe the specifi ed ambient tem-
perature (see "Intended use" on
page EN-4).
You can adjust the temperature in the chest
freezer with the temperature controller. Select
a cooling capacity between “1’”and “6”. “1” is
the highest temperature, whereas “6” is the
lowest.
The freezer is designed for a specific am-
bient temperature (see "Intended use" on
page EN-4). The power consumption and the
temperature in the chest freezer can increase if
– the ambient temperature is exceeded or
goes too low,
– the lid of the chest freezer is opened often
or for too long.
The ideal temperature is –18 °C.
OFF
6
5
4
3
2
1
1. Set the temperature controller (3) to the
average cooling capacity “4”. This setting
is sufficient for normal ambient temper-
atures if you do not open the lid of the
freezer for long and always close it prop-
erly.
– To set a higher temperature, turn the
temperature controller towards “1”.
– To set a lower temperature, turn the tem-
perature controller towards “6”.
2. Adjust the temperature in the freezer ac-
cording to the ambient temperature (e.g.
in summer towards “6”) and the amount of
stored food.
You ideally need a freezer thermom-
eter to be able to control the cooling
effi ciency. Put it in one of the freezer bas-
kets (2). If you set a lower temperature, you
will need a higher cooling performance. This
increases the energy consumption.