HGS14355FW, HGS14355FS
Setting up the freezer
EN-12
6. Screw the hinge plate as well as the two screws back onto
the respective opposite side.
7. Place the cover back onto the freezer, ensuring that the tem-
perature controller
1
fits in the designated opening again.
Push down on both sides (left and right) of the front of the
cover until you hear it click into place.
8. Screw the two screws tightly back onto the cover. To do this,
use a cross-head screwdriver. Replace both screw covers.
12. Move the hinge pin to the opposite side of the hinge plate. To
loosen and tighten the nut, use a 10 mm spanner or the un-
derside of a screw foot.
1.
2.
9. Tip the freezer backwards (maximum 45°) so that you can
also move the lower door hinge.
10. Unscrew both front levelling feet.
11. Unscrew the lower hinge plate. To do this, use an 8mm span-
ner or a cross-headed screwdriver.
15. Carefully stand the freezer upright.
16. Reinsert the blind plug on the opposite side of the door
You have successfully changed the door hinges.
13. Screw the hinge plate tightly back onto the opposite side.
Make sure that the hinge pin is in the hinge bushing of the
door.
The door will now function properly again.
14. Screw both adjusting feet securely back onto the freezer.
