Page EN-35
Troubleshooting table
Problem
Possible cause
Solution
The display
(9) is illuminated
although dish-
washer salt has
been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
The water is
not running or it
is running only
very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so that
it is not kinked (see “Connect the inlet
hose” on page EN-32).
The water tap is not on
properly.
Turn the water tap on completely.
The water is not
running off or
only very slowly.
The filters are blocked.
Clean the filters (see “Checking and
cleaning the filters” on page EN-27).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the proper man-
ner (see page EN-31).
The dishwasher
is not watertight.
The door seal is defective.
Have the door seal replaced
(see “Service” on page EN-37).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see “Service” on page EN-37).
The dishwasher
can be switched
on/off, but not
cannot be
operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are resi-
dues or streaks
on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see “Chang-
ing the rinse aid dose” on page EN-15).
There is no dishwasher salt.
Add dishwasher salt (see “Adding dish-
washer salt” on page EN-17).
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
