Page EN-31
Set-up, connection and initial start-up
2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the condensation protection film sup-
plied (c) to the underside of the worktop.
In this way, you will avoid damage to the
work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired
position.
(31)
5. In order to compensate for uneven floor
surfaces and set up the dishwasher on a
level horizontal base, you can screw the
four adjustable feet (31) in or out.
The adjustable feet have slots around
their circumference. Insert a screwdriver
and turn the adjustable foot.
Use a spirit level to set up the dishwasher.
Having the outlet hose
connected
NOTICE
Malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
■
Make sure that the waste water can
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
■
Ensure that there are no kinks or dam-
age to the outlet hose.
■
Make sure that the end of the hose is
not submerged in the pumped water.
■
Do not extend the outlet hose or
replace with another drainage pipe.
Ø
≥
40 mm
max. 1 m
You can connect the end of the outlet hose in
two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (siphon)
of your washing/dishwashing basin.
Technical measures are required for this.
For this reason, only plumbing experts or
members of our service team may connect
the outlet hose (see page EN-37).
The outlet hose must be a maximum of 1 m
above the floor.